After replacing some resistors I pulled some of the through holes from the pcb.
The top copper caps it would seem.
Will this cause some problems, and is ti possible to repair?
Thanks in advance.
Through Hole Damage
3 posts
• Page 1 of 1
Through Hole Damage
by NovaKaine » Sun Dec 18, 2011 9:17 am
- NovaKaine
- Posts: 150
- Joined: Mon Jun 23, 2008 1:38 pm
- Location: Lancaster Tx.
Re: Through Hole Damage
by jman 31 » Sun Dec 18, 2011 12:08 pm
Can you post some photos? I have repaired issues like this in the past by scraping the soldermask off of the affected trace and connecting a short piece of wire to the nearest portion of the trace that is still intact. This is not an easy fix, but possible. If you have double sided boards and the top copper is connected to the bottom copper through the hole, then you may need to solder the top and the botom of the component to regain the continuity from the top to the bottom of the PCB.
- jman 31
- Posts: 536
- Joined: Thu Jul 10, 2008 10:51 pm
- Location: USA
Re: Through Hole Damage
by NovaKaine » Tue Dec 20, 2011 3:21 pm
Oh nevermind found some good fixes online, check out rear window defroster fluid.
It's liquid, conductive and fast drying.
Works great for the thru hole damage.
It's liquid, conductive and fast drying.
Works great for the thru hole damage.
- NovaKaine
- Posts: 150
- Joined: Mon Jun 23, 2008 1:38 pm
- Location: Lancaster Tx.
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 148 guests