www.megadrum.info

Hi
I have a megadrum with firmaware 20100613, and I have doing some testing with a
only one piezo electric mic glued on a little piece of wood.
Testing with MIDI-ox every stroke on the piezo in the midi ox monitor I have two and three note on ... I ll post a pic of the screen.
At first I dont need great sensibilty, (I need stroke lightly on piezoelectric)
Anyone can help me?

thanks

First, upgrade the firmware to the latest version.
After this, if problems persist, possible causes cab be:

1. Bad or incorrect wiring of the piezo to an input.
2. Bad soldering on the board.
3. Incorrect settings.

thanks Dmitri!

I have to learn and I will try to do!

its a kit purchased to sinthex.

if I modify the curves Can I fixed the problem? wich would work better

thank you very much.

Vibrafonica wrote:if I modify the curves Can I fixed the problem?

Curves are not for fixing problems.

thanks a lot!!!!

with this procedure , that upgrade work fine in my version ????

viewtopic.php?f=3&t=1252

thanks again