www.megadrum.info

With single piezo selected I can't trigger input 2 and 3 at the same time. With dual 3 way selected it has the same issue with inputs 3 and 4. Is there some thing else I need to change?

What kind of pads are you trying to configure?

Single piezo.

And I guess this single piezo is connected to inputs 2 and 3 simultaneously?

No, 1 per input atm.

And did you configure inputs 2 and 3 as single inputs?
What did you do with XTalk and XTalkGrp on these inputs?

I was having xtalk issues, just because of the nature of the set uo, and raised thr threshold to compensatte. Sorted this and now have it down to 22. The pads using these two inputs are 1 metre apart, so its not a xtalk issue.

airflamesred wrote:The pads using these two inputs are 1 metre apart, so its not a xtalk issue.

They're 1 meter apart but you still have not changed default values of either XTalk or XTalkGrp on these inputs?

Yes xtalk at 5. I haven't changed the group.

So you have read about XTalkGrp in http://www.megadrum.info/content/pads-settings and still left inputs 2 and 3 in the same XTalkGrp even though pads connected to them are 1 meter apart. Why?