www.megadrum.info

Hi

I have a ili9341 tft which I believe is supported. Can anyone help with the correct pin out connections to get it up and running.

Pins on unit are:
reset
cs
vcc
dc/rs
gnd
reset
sd1/mosi
sck
led
sd0/miso

What are the corresponding pins on the MD lcd connector?

Many thanks

You can see pinout for LCD displays in 'MegaDrum kit - instruction manual.pdf' from http://www.megadrum.info/forums/viewtop ... f=3&t=1420
For ili93240 you must connect pins 11 and 12 of the LCD connector over a 200Ohm resistor (for old bootloaders) or over a jumper (for new bootloaders)

dmitri wrote:You can see pinout for LCD displays in 'MegaDrum kit - instruction manual.pdf' from viewtopic.php?f=3&t=1420
For ili93240 you must connect pins 11 and 12 of the LCD connector over a 200Ohm resistor (for old bootloaders) or over a jumper (for new bootloaders)

I was reading the wrong manual! Is this not possible with the LITE board? (no P6 connector)

No, it is not possible with Lite boards.

dmitri wrote:No, it is not possible with Lite boards.

OK thanks