Page 1 of 7
first time user
Posted:
Mon May 09, 2011 7:01 amby Leon
Hi There
Please help????
I've build the two PC boards complete, received the chip with bootloader from you and I have programmed the USB chip succesfully. Now I am not sure what to do from here. Please remember that I only want to use it from my pc and dont have the LCD, Keyboard connected at all.
It will be much appreciated if someone could help me..
Thanks
Leon
Re: first time user
Posted:
Mon May 09, 2011 8:59 amby dmitri
What help are you asking for?
Re: first time user
Posted:
Mon May 09, 2011 10:18 amby Leon
Do I still need to program anything?? (like firmware or software??)
Re: first time user
Posted:
Mon May 09, 2011 10:23 amby dmitri
You programmed PIC and you got Atmega already programmed so you don't need to program anything else.
Re: first time user
Posted:
Mon May 09, 2011 10:55 amby Leon
So do I just plug it into the computer and it will work then??
Re: first time user
Posted:
Mon May 09, 2011 11:06 amby dmitri
If everything is soldered and connected right than yes.
Re: first time user
Posted:
Tue May 10, 2011 12:30 pmby Leon
It picked it up in the system tray once and not again after that...... and I still can't get it to work
Re: first time user
Posted:
Tue May 10, 2011 12:32 pmby dmitri
Leon wrote:It picked it up in the system tray once and not again after that...... and I still can't get it to work
I didn't understand this.
Re: first time user
Posted:
Tue May 10, 2011 12:35 pmby Leon
I connected the MD to my pc via USB, and then it showed that is picking up a new audio devive, bu when i unplugged it, it didn't detect it anymore, so I can't get my pc to see the MD
Re: first time user
Posted:
Tue May 10, 2011 12:43 pmby dmitri
Check for bad soldering, shorts, breaks. If there were shorts you might have damaged your PIC. I once half fried one PIC - I could still program it but it didn't talk over USB.