Setting pedal HITHAT
3 posts
• Page 1 of 1
Setting pedal HITHAT
by patrick40 » Sun Aug 24, 2014 4:46 pm
Hello all. I have some problems setting up my pedal HITHAT. This is a brand ALESIS pedal, pedal released I measure 150Kohms the jack and pedal pressed, I measure 1Kohms. I tried two configurations, pot or F.contr, the thresholds are too low in pot and I have to LvlsRevers in F.contr without success. Would you give me a solution? best regards. Patrick
- patrick40
- Posts: 6
- Joined: Sun Jul 27, 2014 9:53 am
Re: Setting pedal HITHAT
by angr77 » Sun Aug 24, 2014 6:46 pm
Hi!
What is the problem? In MDM...can you see the pedal moving in the midi monitor? Have you performed a proper high/low level sequence in MD for your pedal? Ohms does not hint about the real problem I am afraid...
Pot=not sending cc:04
Fcontrol= sends cc:04
Angr77
What is the problem? In MDM...can you see the pedal moving in the midi monitor? Have you performed a proper high/low level sequence in MD for your pedal? Ohms does not hint about the real problem I am afraid...
Pot=not sending cc:04
Fcontrol= sends cc:04
Angr77
Sonor, Drum-Tec heads, Roland CY14, CY12&15R, 2x BT-1 & VH11, 12, 13, Triggera D11, 2xD14, Pintech Dingbat, Letric Moo, Quartz triggers, 2xARM based MegaDRUM, PS Board, M-Audio FT Ultra 8R, Addictive Drums 2.1.6, Surface Pro 5 http://zourman.com
- angr77
- Posts: 622
- Joined: Tue Nov 29, 2011 10:42 pm
- Location: Stockholm, Sweden
Re: Setting pedal HITHAT
by patrick40 » Mon Aug 25, 2014 3:49 pm
Hi. I finally succeeded to adjust my pedal HITHAT in Pot position but with manual levels and especially from the MDM, which greatly facilitated my task by observing the MIDI triggers in the monitor. Thank you for your advice because I had completely ignored this possibility and persisted me to make adjustments on the front of the module MD. Again thank you. Patrick
- patrick40
- Posts: 6
- Joined: Sun Jul 27, 2014 9:53 am
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 38 guests