Page 1 of 1
Setting pedal HITHAT
Posted:
Sun Aug 24, 2014 4:46 pmby patrick40
Hello all. I have some problems setting up my pedal HITHAT. This is a brand ALESIS pedal, pedal released I measure 150Kohms the jack and pedal pressed, I measure 1Kohms. I tried two configurations, pot or F.contr, the thresholds are too low in pot and I have to LvlsRevers in F.contr without success. Would you give me a solution? best regards. Patrick
Re: Setting pedal HITHAT
Posted:
Sun Aug 24, 2014 6:46 pmby angr77
Hi!
What is the problem? In MDM...can you see the pedal moving in the midi monitor? Have you performed a proper high/low level sequence in MD for your pedal? Ohms does not hint about the real problem I am afraid...
Pot=not sending cc:04
Fcontrol= sends cc:04
Angr77
Re: Setting pedal HITHAT
Posted:
Mon Aug 25, 2014 3:49 pmby patrick40
Hi. I finally succeeded to adjust my pedal HITHAT in Pot position but with manual levels and especially from the MDM, which greatly facilitated my task by observing the MIDI triggers in the monitor. Thank you for your advice because I had completely ignored this possibility and persisted me to make adjustments on the front of the module MD. Again thank you. Patrick