timero wrote:hi! im new with diy.. it my 1st time trying since i really want to build this beast. i have no knowledge in schematics that's why im studying through the net for a week now just to gain a few understanding of building the megadrum.. now i think i can start building my own megadrum but i just wanted to ask some things before i begin with this project.
Judging by your words and questions below I should say that MegaDrum will be a too difficult project for you. You may many hours of your time and end up with frustration.
1st. i wanted to use 4851's so i wont have to use the BATs. i read in this thread that i can still use the analogue pcb (just remove the BATs and replace input protection resistors with jumpers)
Q: what resistors should i replace? Are they R2,R6,R10 and R14?
Search the forum, it's been answered many times.
2nd. I really don't know where to use the IC sockets (are they suppose to be connected to the pins of the IC's?), PINS array 36x1 and cable mounting sockets?
First of all, find out what IC sockets are and what they are used for.
i have done many things that are far beyond knowledge but still managing to finish it with successes. thanks for the reply and thanks for this great project.... peace...
) and I wonder if this was a mistake.