Question about Synthex kit

[educr0w]

Hello, I'm building Synthex kit.
Now I'm building 32 inputs board.
I was soldering when I decide to test continuity between pins.
I put the multimeter in continuity (beep mode) and I started with aux7 / aux6 pins
and check them with others pins.

The arrow represents the red cable of the multimeter and the dot represent the other
pin(were I put black cable) that make sound with the multimeter.



There are a lot of connected pins, is that ok??
I'm afraid I make a mistake soldering.

I will appreciate any help with this.

Thanks!
Eduardo.-

[Synthex]

All is right
They are switched jacks.
With no plug into the jack, all inputs are switched to ground.